Velleman CAMCOLD 23 Notice D'emploi page 10

define the top, bottom, left, and right edge of the area.
7.8 Privacy
Use this function to block a part of the image where you don't want
to view activity. For example, if part of the image shows a public
area where recording may be illegal. You can define up to 8 areas.
Display: PRIVACY
OFF Privacy is switched off
ON Privacy function is active. Use the settings below.
• Select which of the 8 areas you want to define in AREA SEL
(1/8 ... 8/8).
Use the TOP, BOTTOM, LEFT, and RIGHT settings to
define the top, bottom, left, and right edge of the area.
• COLOR: sets the colour of the privacy area.
• TRANSP: sets the transparency for the privacy area.
• MOSAIC: creates a mosaic pattern in the privacy area. This
is useful if you want to make an area private, but still want
to use it for motion detection.
7.9 Day / night
The camera can switch automatically between colour images in day
conditions and black-and-white images in night conditions. Use this
function to control the day/night behaviour of the camera.
Note: black-and-white images are much clearer and contain less
noise at low light levels.
Display: DAY/NIGHT
COLOR The camera always makes colour images.
B/W The camera always makes black-and-white images.
• BURST: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
AUTO The camera makes colour images during the day and black-
and-white images during the night. Use the settings below.
• BURST: you can switch burst on or off to improve the
image quality. The burst function sends a colour signal to
the monitor in B/W mode. This may degrade the clarity
of the image.
V. 01 – 08/05/2012
CAMCOLD23
10 ©Velleman nv