Carat P-3500 Série Mode D'emploi page 30

GB
f) Insert the tube-holding rod into the appropriate
slot (photo 4).
4 4
4. Fitting and removing the diamond-tipped disc
WARNING !
Slacken the three nuts on the disc guard and
remove the disc.
Remove the disc-locking nut using a 30 mm
spanner and a 5 mm Allen wrench.
5 5
WARNING !
THE DISC LOCK NUT HAS A LEFT-HAND
THREAD.
• Proceed to fit the disc, checking the rotation
direction clearly marked on the tool.
• Tighten the disc and replace the disc guard.
• In order to remove the disc, carry out the above
instructions in reverse order.
5. Handling
The P-3500 can be easily moved using the carrying
handles.
Before moving the machine make sure that:
- the motor-bogie is locked using the knob on
the sliding beam;
- the legs are in the moving position (photo 7);
- the machine is in the 30° position;
- the motor head is locked using the recoil
lever;
- the tube-holding rod has been extracted from
its slot.
TO MOVE THE MACHINE:
a) use a four-part sling, connected to the hooks in
the moving handles (photo 6);
6 6
b) with the help of another person, move the
machine using the carrying handles (photo 7).
7 7
30