Carat P-3500 Série Mode D'emploi page 35

13. Forward cutting system (optional)
The "FORWARD CUTTING SYSTEM" accessory
allows the forward or backward movement of the
cutting disc to be adjusted in a very precise manner,
using the hand wheel found on the front stanchion
on the machine.
WARNING !
CONSIDERING THE
SENSITIVITY OF THIS ACCESSORY, PROCEED
WITH CAUTION IN
ACCIDENTAL BLOCKAGES OF THE CUTTING
IMPLEMENT.
2 2 3 3
14. Maintenance
SETTING THE CARRIAGE
The carriage is fitted with two registers for the
adjustment of the vertical play of the motor head.
To position the carriage correctly, proceed as
follows:
- using a 3 mm hexagonal male wrench, turn the
two front adjustment dowels (A) until there is no
more play left (photo 24);
2 2 4 4
HIGH LEVEL OF
ORDER TO AVOID
- repeat the procedure on the two rear
adjustment dowels (B) (photo 25).
2 2 5 5
WARNING !
CLOSE EACH OF THE FOUR REGISTERS TO
THE SAME EXTENT IN ORDER TO OBTAIN
ADEQUATELY SMOOTH SLIDING.
CLEANING
WARNING !
DO NOT WASH THE MACHINE WITH A
PRESSURISED JET OF WATER.
It is possible to wash the P-3500 easily by loosening
the locking nuts and removing the working surface.
Drain working residue from the machine using the
plug on the bottom of the collection tank.
2 2 6 6
35
GB