EINHELL DSP 15 Mode D'emploi page 7

2. Assembly
The sprayer comes fully assembled except for
the hand lever.
The spray tube also comes fully assembly and
has to be tightly screwed to the handle with the
union nut.
Remove the cover (C) by unscrewing the six
recessed head screws (B) at the rear (Figure 2).
Unscrew the two hexagon socket-head screws
(C) from the pump axle (A) (Figure 3).
Fasten the pump lever to the pump axle with the
screws (C) (Figure 4). The pump lever has to
point forward. Use the wrench (B).
Insert the collar in the half-housing.
Screw the cover (C) back in position (Figure 2).
Make sure that the collar and - on the other side
- the spray hose are correctly seated in the
bushing and are not squashed between the two
plastic parts.
2
C
B
A
3
4
GB
7