Error Displays/Messages - Sony CDX-CA900 Mode D'emploi

Automatic tuning is not possible.
• The local seek mode is set to "on."
t Set the local seek mode to "off" (page
22).
• The broadcast signal is too weak.
t Perform manual tuning.
The "ST" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set to the monaural reception mode (page
22).
A programme broadcast in stereo is heard
in monaural.
• The unit is in monaural reception mode.
t Cancel monaural reception mode (page
22).
RDS
The Seek starts after a few seconds of
listening.
The station is non-TP or has a weak signal.
t Press (TA) repeatedly until "TA·······off"
appears.
No traffic announcements.
• Activate "TA."
• The station does not broadcast any traffic
announcements despite being TP.
t Tune in another station.
PTY displays "--------."
• The current station is not an RDS station.
• RDS data has not been received.

Error displays/Messages

Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
Blank* 1
No tracks have been recorded on an MD.*
t Play an MD with recorded tracks on it.
Error* 1
• An inserted CD is dirty or inserted upside
2
down.*
t Clean or insert the CD correctly.
• An inserted CD/MD cannot play because of
some problem.* 2
t Insert another CD/MD.
High Temp
The ambient temperature is more than 50°C.
t Wait until the temperature goes down
below 50°C.
NO Disc* 1
No disc is inserted in the CD/MD unit.
t Insert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
t Insert the magazine in the CD/MD unit.
NO Music
A CD which is not a music file is inserted in
the MP3 playable CD unit.
t Insert a music CD in the MP3 playable CD
unit.
Not Ready
The lid of the MD unit is open or the MDs are
not inserted properly.
t Close the lid or insert the MDs properly.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
t Press the RESET button on the unit.
*1 When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2 The disc number of the disc causing the error
appears in the display.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
continue to next page t
2
31