English
Technical Information
Flow rate (max)
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• This showerhead is for use with rough 26909181
(not included).
• Nendo showerhead 26031001 includes a low
voltage transformer.
• The transformer must be connected to a properly
installed and grounded 110 V GFCI wall switch.
The switch must be installed by a licensed,
professional electrician following all applicable
local electrical codes.
• The transformer must be installed in the wall in
a safe, dry, accessible location. It should be
installed in a standard electrical box larger than
2⅜" diameter (not included).
Do not install the transformer inside
the 26909181 rough.
This unit meets or exceeds the following:
•
ASME A112.18.1
•
CSA B125.1
•
Listed by IAPMO for use in the US
and Canada
This unit meets or exceeds the following:
•
UL 1598, 3rd ed./ CSA C22.2
No. 250.0-08
•
UL 8750, 1st ed.
•
Listed by IAPMO for use in the US
and Canada
2
2.5 GPM
• The transformer includes 7 meters (22.9 feet) of
cable to connect the transformer to the light.
• The plastic conduit included with the rough may
not be permitted by local code in some areas. In
this case, the installer must provide code compli-
ant ¾" conduit. Hansgrohe is not respon-
sible for the cost of the conduit.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve (not
included) must be no higher than 120°F. In
Massachusetts, the maximum output temperature
can be no higher than 112° F.
• This showerhead is for use with an automatically
compensating valve rated at 8.3 L/min (2.2
GPM) or less.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.