Changing The Blades - ATIKA AMA 2300 Notice Originale

 Do not tilt or transport the machine (relocation) while the mo-
tor is running.
 Make sure that the motor is free from waste material and
other material accumulation to protect it against damage and
to prevent fire.
 When filling, be careful that no pieces of metal, stones, bottles
or other objects unintended for processing, enter the filling
hopper.
 Power off the machine before attaching or removing the col-
lecting bag. Power off the machine before attaching or remov-
ing the collecting bag.
 Immediately switch off the equipment and allow it to come to a
stop, if foreign objects enter the filling hopper or if the equip-
ment starts to make unusual noises or vibrates. Remove the
mains plug and carry out the following checks:
 inspect for damage,
 replace or repair damaged parts,
 check the equipment and tighten loose parts.
You must not repair the equipment yourself if you are
unauthorized to do so.

What can I shred?
Yes:
 organic household and garden waste
e. g. hedge and tree cuttings, dead flowers and vegetable
kitchen waste.
No:
 glass, metal, plastic, plastic bags, stones, cloth, roots with
soil, food left-overs, fish or meat.

Special tips on shredding:
 Branches, twigs and wood should be broken down immediate-
ly after they have been cut.
 Material of this kinds gets very hard when it is dry, and the
maximum allowed branch diameter to be processed has to
be reduced.
 Remove any side shoots from branches with a large number
of twigs.
How to shred garden and kitchen waste with hight water con-

tent and a tendency to clog
 to prevent the machine from clogging, alternate waste with
wood containing material.
 Do not allow the shredded material to pile up too high in the
area of the ejection opening. This can lead to shredded mate-
rial blocking the ejection channel, and backing up to the filler
opening.
 Clean out the filler opening and ejection channel thoroughly if
the machine becomes blocked. Before doing this, switch the
motor off and disconnect the machine from the mains power
supply.

Use a tamper or hook to remove jammed objects from
the hopper or ejection slot.
 Please do not exceed the maximum branch diameter speci-
fied (cutting fresh wood) for your appliance ( see "Technical
data"). Depending on the wood's nature and freshness the
maximum branch diameter the machine can process may be
smaller.
14
 The blades largely pull the material into the machine by them-
selves.
 Strong branches may cause overloading. This can be avoided
by pulling them back from time to time.
 If the machine is overloaded, a protective motor switch en-
sures that the machine turns itself off automatically.
 Turn the shredder on again after about 5 minutes.
 If you cannot turn on the machine after this waiting time re-
fer to „Operational faults".
C h a n g i n g t h e b l a
C h a n g i n g t h e b l
Remove the mains plug before changing the blades.
Risk of injury to the fingers and hands when carrying out
work on the blade unit. Wear protective gloves.
Open the machine.
Fix the blade.
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
d e s
a d e s