Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not allow the shredded material to pile up too high in the
area of the ejection opening. This can lead to shredded mate-
rial blocking the ejection channel, and backing up to the filler
opening.
Clean out the filler opening and ejection channel thoroughly if
the machine becomes blocked. Before doing this, switch the
motor off and disconnect the machine from the mains power
supply.
Please do not exceed the maximum branch diameter speci-
fied (cutting fresh wood) for your appliance (∅ see "Technical
data"). Depending on the wood's nature and freshness the
maximum branch diameter the machine can process may be
smaller.
The blades largely pull the material into the machine by them-
selves.
Strong branches may cause overloading. This can be avoided
by pulling them back from time to time.
If the machine is overloaded, a protective motor switch en-
sures that the machine turns itself off automatically.
Turn the shredder on again after about 5 minutes.
−
If you cannot turn on the machine after this waiting time re-
−
fer to „Operational faults".
C
h
a
n
g
i
n
g
t
h
e
b
l
a
C
h
a
n
g
i
n
g
t
h
e
b
l
Remove the mains plug before changing the blades.
Risk of injury to the fingers and hands when carrying out
work on the blade unit. Wear protective gloves.
Open the machine.
Fix the blade.
14
d
e
s
a
d
e
s
Reduced output
One edge of the knife has become blunt:
Turn knife so that you can use the other edge.
All knive edges have become blunt:
Replace with new set of knives (order-no. 382425).
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
•
Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
Be sure to have removed any tools from the machine after
completion of service work.
•
Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
− Do not clean the machine with running water or high-pressure
cleaners.
− After each operation treat bare metal parts with an environ-
ment-compatible biodegradable spray oil to protect them
against corrosion.
Left-hand thread
c
l
e
a
n
i
n
g
c
l
e
a
n
i
n
g
Publicité
Chapitres
Table des Matières
