Safety Instructions - Indexa DVT-20 Mode D'emploi

Monitor 3.5" TFT-LCD
Audio/Video output 3,5mm Stereo socket
Video output 1 Vp-p / 75 Ohm
Audio output 1 Vp-p / 600 Ohm (mono)
SD-card max. 32 GB
Operating temperature - 10° C to + 40° C
Protection class IP 20
Dimensions housing 131 x 86 x 26 mm
Mains Adapter KSAFE1500150W1EU
Power supply 100 - 240 V ~ 50 / 60 Hz, 0.6 A
Output 15 V
Application indoor use only
Mains Adapter KSAB0500100W1EU
Power supply 100 - 240 V ~ 50 / 60 Hz, 0.18 A
Output 5 V
Application indoor use only

6. Safety instructions

The following instructions are provided for your safety and satisfaction during
operation of the device. Note that non-observance of these safety instructions
results in significant risks of accident.
Explanation of symbols and terms used:
Danger! If this point is not heeded life and health is endangered.
Attention! Non-observance of these instructions puts property at risk
of damage.
Tip! Optimum results will be achieved by observing these instructions.
Danger!
! Do not leave small children unsupervised with the device, packaging
material or small parts. Otherwise there is a risk of fatal injury due to
choking or suffocation.
! Do not damage any gas, electricity, water or telecommunication lines
during drilling and fixing work. Otherwise there are dangers of fire,
personal and fatal injury.
! Treat the cables carefully. Lay these so that they cannot be damaged and
do not present any tripping hazard. Do not pull the cables over sharp edges
and do not crush or crimp them elsewhere. Otherwise there are dangers of
fire, personal and fatal injury.
! Prevent the mains adapters from coming into contact with moisture and do
not submerge in water. Otherwise there is a danger of fatal injury.
! Only operate the device from the supplied power supplies. Before
connecting the power supply to the mains, ensure that the mains current
complies with 230 V ~, 50 Hz and is fitted with a fuse according to
regulations. Otherwise there are dangers of fire and fatal injury.
Attention!
! Do not place the equipment near fire, heat or in areas of high temperature.
! Protect the equipment and the cables against strong magnetic or electrical
fields and against strong mechanical loads and vibrations.
DC, 1,5 A
DC, 1 A
! Only use the equipment with the supplied original parts or original
accessories.
! Before assembly and use check that all parts are included and that they are
undamaged.
! Remove the mains adapters from the mains outlet when the device is not
required for a longer time.
! Do not connect any damaged device (e.g. damage in transit). Repairs to
the equipment must only be performed by specialists.
Tip!
! This system transmits and receives radio-frequency signals. If the system is
not installed and used according to the instructions it may cause
interference with other apparatus and just as other apparatus may
interfere with the system. Interference can be reduced by repositioning the
system.
7. Location of equipment
Before mounting the devices plan their location. Check the function of the
camera and the wireless reception from the desired location.
Observe the following points:
Outdoor station:
! Mount the outdoor station at such a height that visitors can comfortably
reach the doorbell button and that the face of the person ringing the bell is
in the field of view of the camera. Pay attention to the height of children in
doing so. The vertical field of view of the camera is approx. 65°.
! The outdoor station is usually installed at the side of the entrance door.
Ensure that the face of a visitor standing in front of the door can be seen on
the monitor. The horizontal field of view of the camera is approx. 85°.
! Position the camera so that no direct light or sunshine falls on the lens.
Avoid strong back lighting behind the visitor: in this case, the person
appears darker on the image. Check the camera image before mounting.
Provisionally connect and commission the device and hold the outdoor
station in the desired position. If necessary, change the camera position
until you have found the desired view. Remember that the position of the
sun changes.
! The camera has infra red illumination [12] for the close range. This is
activated by the daylight sensor [11]. You can improve the quality of the
image at night by using additional illumination.
! If you want to install the outdoor station outdoors, it must be protected
against direct rainfall. The mains adapter must be in a dry location. The
connection to the mains adapter cable must be protected against moisture.
! Ensure that there is a possible cable routing for the mains adapter cable at
the installation location.
Use of the antenna cable.
For the best possible wireless reception the antenna cable can be used, in order
to position the antenna on the inside of the house wall. In this case the antenna
cable and the sun shield must be used (see Fig. D). A hole for the antenna cable
and if required also for the mains adapter and door release cable above the
outdoor station is necessary.
GB - 29