Bosch TES 503F Série Mode D'emploi page 39

en
2. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
3. Rinse all parts with clear water and dry
them.
4. Reassemble all the parts and replace
fully in the appliance.
¡
Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
e
1. Select by turning the rotary knob (14).
2. Place an empty glass under outlet (7).
3. Press the start button (10).
The appliance rinses.
In addition to the automatic cleaning pro-
gramme, the brewing unit (5a) should be
removed regularly for cleaning (see figure E
at the start of the operating instructions).
1. Switch the appliance off at the power
on/off switch O / I (9). No buttons are lit.
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5e) on the brewing
unit (5a) completely to the left.
4. Press the eject lever (5d) down fully.
The brewing unit is released.
5. Grasp the brewing unit (5a) by the
recessed grips and remove carefully.
6. Remove the cover (5f) of the brewing
unit and rinse the brewing unit (5a)
thoroughly under running water.
7. Thoroughly clean the brewing unit sieve
under the running water.
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher.
8. Wipe out the inside of the appliance
thoroughly with a damp cloth and
remove any coffee residues.
9. Allow the brewing unit (5a) and the
inside of the appliance to dry.
10. Replace the cover (5f) on the brewing
unit and reinsert the brewing unit (5a)
fully into the appliance.
11. Press the eject lever (5d) up fully.
12. Slide the red lock (5e) fully to the right
and close the door (5b).
35
TES503F.. | 02/2014