Creating Offset Felling Cut - NORDFOREST Titan 80 Mode D'emploi

Operating the Nordforest Titan 80 Mechanical Felling Wedge
50 Nordforest Mechanical Titan 80 Felling Wedge
›
Extend the felling cut evenly at the top and bottom so that the
Nordforest Titan 80 Mechanical Felling Wedge can be inserted at
least to beyond the sixth tooth row.
›
Hold the Nordforest Titan 80 Mechanical Felling Wedge by the
hand grip and press it perpendicularly to a depth of approx. 12 cm,
but at least over the sixth tooth row into the vertical wood fibres
(see marking).
The tooth rows on the steel spring plates bite into the wood fibres.
›
Turn the ratchet until the Nordforest Titan 80 Mechanical Felling
Wedge is straight and firmly seated in the wood.
If the wood is frozen, the Nordforest Titan 80 Mechanical
i
Felling Wedge must be inserted into the wood deep enough
to grip securely.

Creating offset felling cut

The creation of the offset felling cut is mandatory. The creation of an
offset felling cut prevents dangerous contact between the Nordforest
Titan 80 Mechanical Felling Wedge and the chain saw chain.
20-076 | 03.2017