Automatic Power-Off (Power Management) - Pioneer PDA-5003 Mode D'emploi

Automatic power-off
(POWER MANAGEMENT)
The Plasma Display is equipped with [POWER MGT.] and
[AUTO POWER OFF] functions; when set, the function
automatically switches the unit to either standby mode or
power off mode whenever a sync signal is not detected
(a warning message is displayed on the screen before the
functions operate).
Note
Always turn off the Plasma Display's main power switch when
not using the display for extended periods of time.
Remote control unit
DISPLAY
STANDBY/ON MENU
/ SET
MENU SET
Display operating panel
1
Press the MENU button to display the menu screen.
M E N U
P I C T U R E S C R E E N
C O N T R A S T
B R I G H T N E S S
C O L O R
T I N T
S H A R P N E S S
P I C T U R E R E S E T
SET ENTER
2 Use the 2/3 buttons to select [SETUP].
[When computer signal is input to INPUT1, INPUT2
or INPUT5 (PDA-5003 only)]
MENU
PICTURE SCREEN
P O W E R M G T.
S I G N A L F O R M AT
D V I S E T U P
INPUT
MENU
2/3
SET
INPUT SCREEN SIZE – VOL +
2/3
INPUT
I N P U T 1
S E T U P O P T I O N
0
:
0
:
: 0
: 0
0
:
MENU EXIT
INPUT1
SETUP OPTION
: O F F
[In all other cases]
MENU
PICTURE SCREEN
C O L O R T E M P.
A U T O P O W E R O F F
D N R
M P E G N R
C T I
P U R E C I N E M A
C O L O R D E C O D I N G
C O L O R S Y S T E M
S I G N A L F O R M AT
SET CHANGE
3
Press the SET button to confirm selection of the
[POWER MGT.] or [AUTO POWER OFF].
The factory default setting is [OFF/DISABLE].
Each time the button is pressed, the setting alternates
as follows:
3 OFF/DISABLE
ON/ENABLE 2
÷ OFF/DISABLE.....
The display will continue in operating mode,
regardless of the presence/absence of an input sync
signal.
÷ POWER MGT.: ON.....
If a sync signal is not detected, a warning message is
first displayed for 8 seconds, after which the display
automatically enters the standby mode, and the
STANDBY/ON indicator flashes green. If a sync signal
is input again later, the Plasma Display automatically
returns to normal operating mode (*1).
*1 Except when input signal is G ON SYNC or composite
SYNC.
÷ AUTO POWER OFF: ENABLE.....
If no sync signal is detected for 8 minutes or more, a
warning message will be displayed, after which the
display's power will switch to power off mode.
4
When the setup is finished, press the MENU
button to exit the menu screen.
Note
The [POWER MGT.] and [AUTO POWER OFF] function must be
set individually for each input (INPUT1 to INPUT5).
To return to operating mode:
÷ To return to normal operation from the [POWER MGT.]
function's standby mode, either operate your computer, or
press the INPUT button.
÷ To return to normal operation from the [AUTO POWER
OFF] function's power off condition, press the STANDBY/
ON button on the Plasma Display or on the remote control
unit.
Operation
INPUT3
SETUP OPTION
: M I D D L E
: D I S A B L E
: M I D D L E
: L O W
: O N
: O F F
: R G B
: A U T O
MENU EXIT
27
En