How To Route Cables - Pioneer PDA-5003 Mode D'emploi

How to route cables

Speed clamps are included with the Plasma Display for
bunching cables together. Once components are
connected, follow the following steps to route cables.
The illustration depicts the PDP-425CMX/PDP-42MXE10
with video card PDA-5003.
1 2
Organize cables together using the provided speed
clamps.
Insert 1 into an appropriate hole on the rear of the unit,
then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach carefully.
To attach the speed clamps to the display
Use the holes marked with the & sign as needed.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over time
and may be damaged when removed.
Installation and Connections
* As viewed from the rear of the display.
Note
Cables can be routed to the right or left.
The illustration depicts the PDP-425CMX/PDP-42MXE10
with video card PDA-5003.
* As viewed from the
rear of the display.
17
En