Connection To Input1 Or Input5 - Pioneer PDA-5003 Mode D'emploi

Installation and Connections
I When using PDA-5004
Connection to INPUT1 and INPUT5
Various components can be connected to the INPUT1 and
INPUT5 jack. After connections are made, on-screen
setup is necessary to match the characteristics of the
connected component. Please see pages 18 to 21 for on-
screen setup after connection.
INPUT5 jack
Output source
Video component/personal
computer (PC) with RGB
output
G ON SYNC
Video component with
component video output
: Connect to this jack.
Note
When making connections to INPUT1, please refer to the Plasma
Display's Operating Instructions.
See Appendixes 1 and 2 (pages 47 to 49) for
information regarding signals and display formats
supported by INPUT1.

Connection to INPUT1 or INPUT5

I When using PDA-5003
Connection to AV components
Connection to AV component equipped with
component video jacks
Make component video connections for AV components
equipped with component video jacks.
When connecting to ANALOG RGB IN (INPUT1)
INPUT1
ANALOG RGB OUT ANALOG RGB IN
(D-Sub) (D-Sub)
On-screen setup is necessary after connection.
Please see pages 18 to 21.
8
En
Y P /C P /C
B B R R
B R
Y P /C P /C
B B R R
When connecting to ANALOG RGB (INPUT5)
ANALOG RGB
G(ON SYNC) B R VD
HD (H/V SYNC)
Connect the Y signal to the G jack, the P
B jack, and the P /C signal to the R jack.
R R
On-screen setup is necessary after connection.
Please see pages 18 to 21.
INPUT5 jacks are all BNC jacks.
If necessary, use commercially available BNC/pin-plug
conversion adapters to make connections.
Note
The Plasma Display and this Video Card are designed to support
component video signals with standard, stable signal levels and
sync signals. As a result, some image disruption may be
generated during use of various special trick play functions on
video components.
I When using PDA-5004
Connection to AV components
Connection to AV component equipped with
component video jacks
Make component video connections for AV components
equipped with component video jacks.
When connecting to ANALOG RGB IN (INPUT1)
INPUT1
ANALOG RGB OUT ANALOG RGB IN
(D-Sub) (D-Sub)
On-screen setup is necessary after connection.
Please see pages 18 to 21.
INPUT5
/C signal to the
B B