Cover Removal - R82 Quokka Guide D'utilisation

COVER REMOVAL

WARNING! Do not take apart the harness. Never remove the
buckle tongues from the harness. They cannot be reattached after
removal. If reassembled incorrectly, the child restraint may not
perform as intended.
1. Loosen the harness by lifting the
harness adjuster lever while pulling
the shoulder straps forward as far as
possible.
2. Unhook the shoulder straps from the
splitter plate on the rear of the child
restraint (Fig. A).
3. Pull the upper harness straps through
the shell and cover to the front of the
child restraint.
4. Remove the buckle and belly pad
(page 30).
5. Gently remove the upper portion of
the cover. Be careful not to damage
the energy absorbing foam.
6. Pull the lower harness straps, buckle
tongues, harness cover, and harness
clip through the lower slots in cover.
7. Remove the entire cover from the
child restraint.
REFITTING THE COVER
To refit the cover, reverse the directions on page 30. Make sure that
the shoulder straps are not twisted, and are properly threaded
through the harness clip, harness cover, cover, foam and shell.
IMPORTANT: Ensure the slots in the cover match the slots in the
shell when re-threading the harness.
CARE AND MAINTENANCE
29