R82 Quokka Guide D'utilisation page 27

Releasing the Harness Buckle
Press the release button and slide both
buckle tongues from the buckle (Fig. G).
IMPORTANT: Periodically clean the harness
buckle to ensure safe operation. See page 28.
Adjusting the Harness Height
1. Loosen the harness by lifting the harness
adjuster release lever while pulling both
harness straps forward as far as possible
(Fig. H).
2. From the rear of the child restraint,
unhook one shoulder harness from the
splitter plate at a time (Fig. J).
3. Pull strap through the shell and cover, to
the front of the restraint.
4. Thread the harness strap through the
appropriate harness height slot (Fig. I).
5. Reattach harness strap to the splitter
plate (Fig. J). Use upper loops for short
settings and lower loops for standard
harness settings (Fig. K).
6. Repeat steps 2-5 for the second harness
strap.
7. Pull harness adjuster strap to tighten the
harness.
8. Verify that both harness straps are
threaded at the same height and are not
twisted.
IMPORTANT:
• Ensure the slots in the cover match the
slots in the shell when re-threading the
harness.
• When upper loops are used, the ends of
harness strap always hang in front of the
splitter plate (Fig. K).
USING child restraint FEATURES
25
UNBUCKLE
UPPER
LOOP
LOWER
LOOP