Silverline 656578 Traduction Des Instructions Originales page 8

GB
Troubleshooting
Symptom Possible Cause Solution
Pressure incorrect Set the correct air pressure according to the specification
Dirt within the mechanism Pour oil into air inlet as per maintenance instructions
Air blockage Operate tool in short bursts to clear blockage
Tool operating slowly
Air leak Check all fittings and hose for air leaks and correct issue by re-
tightening, using PTFE tape or replacing
Blockage in gauze mesh filter Remove Quick Connector (3) and clean mesh filter
Dirt or rust in mechanism Try 'Tool operating slowly' solutions
Dirt or rust in mechanism Tap tool gently with a soft mallet
Tool seized
Dirt or rust in mechanism Free mechanism by rotating drive manually when disconnected from
air line
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
Tool will not stop after trigger is
fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8