Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.
Set up
Control panel
o
Large LCD Display with backlight
This backlighted LCD display indicates the fixture is DMX addressed, the fixture status, set up values ..etc
Main Menu
SET
Run mode
DMX Address
Channel Mode
Invert PAN
Invert Tilt
Swap Pan-Tilt
Encoder Pan-Tilt
No DMX Signal
MOVING BEAM 2R MkII Manual Ver. 1.00
Random
Sound
DMX
AUTO 1
AUTO 2
AUTO 3
AUTO 4
DrawUp8
Forward 0
F-Stand8
F-Sleep8
0-512
15-19
ON/OFF
ON/OFF
ON/OFF
ON/OFF
KEEP
CLEAR
Page 15
Publicité
Table des Matières
