Dmx Connection; Set Up; Panel Control - Evolite EVO FUSION 5R Mode D'emploi

Always secure your fixture with a safety cable !
o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.

SET UP

Panel control

EVO FUSION 5R Manual Ver. 1.00[Texte] Page 15