Features; Pump Features - Stryker TP600 Manuel D'utilisation

PUMP FEATURES

Easy to Use See KEYPAD FEATURES on
Keypad
Attached hose 10 ft (305 cm) dual hose. Connectors allow pads to be connected to the pump (Figures 1A
and 1B,
Flow indicator Indicates no flow. Turns off heater if pump is tipped.
Warm/Cool Three setpoints on the TP600 series.
Delivery Four temperature setpoints on the TP700 series.
Therapy Cycles Choose from 20-minute, 30-minute, or Continuous cycles.
(TP700 series
only)
On/Standby Indicates power is supplied to the unit.
Button
Over Temp Safety Limit thermostat shuts off heater if the high temperature limit is exceeded.
Thermostat
Self Check Automatic system check at startup.
Hose/cord Convenient and easy storage areas for hose and cord.
Management
Comfortable Designed for a more comfortable grip when moving the pump.
Handle Design
Dual Micro Two electronic circuits, one over temperature sensing circuit.
Processor
Tethered Easy- Prevents misplacing the cap. Only 1/4 of a turn is needed to remove or secure the cap.
Open Cap
Handle Vents The vents in the handle allow air flow to keep the motor and heater inside the unit cool.
Easy to Use Keypad
Flow Indicator
Temperature
Setpoints for warm
or cool delivery
Therapy Time Cycles
(TP700 series only)
1-8

Features

page 1-9
page 1-5).
On/Standby Button
Handle Vents
Figure 2: T/Pump Features
101515 REV C
(TP600 series) and page 1-10
Comfortable Handle
Tethered Easy-Open Cap
Cord storage
Hose storage
Hose Connections
(TP700 series).