Assembly - Ryobi EXPAND-IT ATTACHEMENTS RY15522 Manuel D'utilisation

UNPACKINg
This product requires assembly.
 Carefully remove the items from the box. Make sure that
all items listed in the packing list are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKINg LIST
Ryobi Expand-it Straight Shaft Trimmer Attachment
™
®
Grass Deflector
Precut Trimmer Line
Operator's Manual
WARNINg:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
WARNINg:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNINg:
Do not connect to power head until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
ATTAChINg ThE gRASS DEfLECTOR
See Figure 2.
NOTE: Install the grass deflector before the attachment is
connected to the power head.
 Remove the wing screw from the grass deflector.
 Insert the tab on the mounting bracket in the slot on the
grass deflector.
 Align the screw hole in the mounting bracket with the
screw hole in the grass deflector.
 Insert the wing screw through the mounting bracket and
into the grass deflector.
 Tighten the screw securely.

ASSEMbLY

grass
deflector
BUtton
jOININg ThE POWER hEAD TO ThE
STRAIghT ShAfT TRIMMER ATTAChMENT
See Figure 3.
WARNINg:
Never attach or adjust any attachment while power head
is running. Failure to stop the engine may cause serious
personal injury.
The straight shaft trimmer attachment connects to the power
head by means of a coupler device.
 Remove the hanger cap from the attachment shaft.
 Loosen the knob on the coupler of the power head
shaft.
6 — English
taB
slot
coUpler
gUide
recess
positioning
Hole
attacHment sHaft
Wing
screW
Fig. 2
poWer Head
sHaft
KnoB
Fig. 3