CHANGING THE
BATTERIES ON THE
REMOTE
TOOLS REQUIRED
• Large flat blade screwdriver
• Socket wrenches
• Adjustable wrench or pliers
• Phillips screwdriver
ELECTRIC SHOCK HAZARD
To avoid the possibility of personal injury, disconnect
power to the unit before installing or servicing.
BEFORE INSTALLING
• Check window opening size against dimensions of your
unit.
• Check condition of window; all wood parts of window
must be in good shape and able to firmly hold the needed
screws. If not, make repairs before installing unit.
• Check for anything that could block airflow; check area
outside window for things such as shrubs, trees, or
awnings. Inside, be sure furniture, drapes or blinds will
not stop proper airflow.
• Carefully unpack air conditioner. Remove all packing
material, and check for all included installation hardware.
Model type:
DAC250EB1GDB DAC150EB1GDB/
Unit height:
18 5/8"
Unit width:
26 1/2"
Min. window opening:
19 1/2"
Min. window width:
Max. window width:
OPERATING INSTRUCTIONS
INSTALLATION INSTRUCTIONS
• Pencil
• Level
• Tape measure
DAC180EB1GDB
17 5/8"
23 5/8"
18 1/2"
31"
26 1/2"
42"
40 1/2"
The remote controller is powered by
one button cell housed in the rear part
and protected by a cover. Remove the
button cell according to the arrow
marked at the back of the remote
controller.
A
B
Fig. 1 INSTALLATION HARDWARE
7/16" locking screw
& flat washer for
window panels
1/2in.(13mm)
long Hex-head
screw
Safety Lock
1/2in.(12.7mm)
long screw and
locknut
3/4" long flat head
bolt and locknut
Sill Angle Bracket
5/16in. long Hex-head
locking screw for top
angle side retainer.
13/16in. (20mm)
screw
Frame lock
Foam insert
Window sash
11
1. Slightly press "A" position
according to the number 1
arrow direction by your
forefinger.
2. Press "B" position and pull it
according to the number 2
arrow direction by your
thumb.
3. The above step 1 and 2
should be done simultaneously
to slide the button cell out.
2 each
4
1
4 each
2 each
2
10
2
2
2
1
seal foam