Clear Memory - JB Systems CMX 24 Mode D'emploi

7. AUDIO INPUT
Line audio input 100mV—1Vpp.
8. REMOTE CONTROL
Full on and Black out remote control connection using 1/4"
Stereo Jack.
OPERATING INSTRUCTIONS
1. ENABLE RECORD
1) Press and hold the Record key.
2) Press Flash1, Flash 5, Flash 6 and Flash 8 in sequence.
3) Release Record, the led is lighting, recording is ready.
2. ERASE ALL PROGRAMS
1) Press and hold the Record key.
2) Press Flash 1, Flash 3, Flash 2, Flash 3 in sequence.
3) Release Record.

3. CLEAR MEMORY

1) Press the Record key and press the REC CLEAR key.
2) Release Record and Rec Clear at the same time.
4a. Record SCENE program
Enable Record (see N° 1)
•
Press MODE SELECT until the green led is on. (1-24 single/
•
preset park)
Choose a page (1, 2, 3 or 4)
•
Bring both MASTER faders fully up (A=open, B=closed)
•
Prepare your scene, adjusting faders 1 to 24
•
Press RECORD: the scene is memorised but has no number
•
yet
Bring both MASTER faders fully down (A=closed, B=open)
•
Press and hold RECORD
•
Choose a Scene number (1 to 12) by pressing one of the
•
bottom FLASH buttons
Release the RECORD button
•
The SCENE is recorded
•
7 CMX 24