Marmitek CONNECT 236 Guide Utilisateur page 9

Power button standby
A small amount of the power is retained to support the memory and remote control sensor
function when the POWER is switched off. This is known as the standby mode. POWER may
be switched On/Off by the Remote Control.
Note: The above device connections are for reference only. Any suitable devices may be
connected to the Input Channels.
Programming the input channel
For easy identification of the AV device connected to the Connect 236, it is possible to name
each of the six inputs on the Input Channel Display.
Press and hold the "SET" button for 2 seconds, the "CH1" on the LCD will begin to flash.
Press the "<" or ">" button to select the desired Input channel (1-6).
Press the "SET" button, the "------"will be flashing.
Press the "<" or ">" button, the LCD will show the first available name: "DVD_1".
Press "<" or ">" button to cycle through all the available names. When the desired name is
displayed press the "SET" button. The name will be stored.
Available names:
CONNECT 236™ 9