Sharp PN-655U Mode D'emploi page 44

PC Operation
IDSL ....... The parameter of this command sets the ID number of the monitor.
The monitor is subject to the next command.
Example:
← The next command is for the monitor with ID number: 2.
IDSL0002
← Searching for monitor with ID number: 2
WAIT
← Found monitor with ID number: 2
OK 002
← Sets volume of monitor with ID number: 2 to 30.
VOLM0030
← Processing
WAIT
← OK response from monitor with ID number: 2
OK 002
← Sets volume to 20.
VOLM0020
← The volume of the monitor with ID number: 1
OK 001
IDLK ....... The parameter of this command sets the ID number of the monitor.
The monitor is subject to all subsequent commands.
Example:
← Following commands are for the monitor with ID number: 2.
IDLK0002
← Searching for monitor with ID number: 2
WAIT
← Found monitor with ID number: 2
OK 002
← Sets volume of monitor with ID number: 2 to 30.
VOLM0030
← Processing
WAIT
OK 002
← Sets volume of monitor with ID number: 2 to 20.
VOLM0020
WAIT
OK 002
← Canceling fixed ID number setting
IDLK0000
← Canceling IDLK
WAIT
← Cancelation complete
OK 002
VOLM0010
← The volume of the monitor with ID number: 1
OK 001
IDCK ...... Provides screen display of the ID number currently assigned to a monitor, and the ID
number currently set for IDLK (if any).
Example:
(After executing IDLK0002)
IDCK0000
ID:001 IDLK:002 ← Returned response. The ID number is also displayed on the monitor screen.
IDCK000+
WAIT
ID:001 IDLK:002
ID:002 IDLK:002
ID:003 IDLK:002
ID:004 IDLK:002
42
E
(Continued)
(the one directly connected to the PC) is set to 20.
(the one directly connected to the PC) is set to 10.
← (Parameter has no meaning.)
← Repeater control
(If a command is used with repeater control, ID designation using IDSL or
IDLK is canceled.)
The IDSL command is
effective only once, for the
immediately succeeding
command.
The IDLK command remains
effective until it is canceled, or
power is shut off.