Safety Considerations - Dustcontrol DC 4000 PCB Notice Originale

Safety Considerations

Read all instructions before attempting to operate this
machine and save these instructions.
Warning! When using electric machines, basic safety
precautions should always be followed to reduce the risk
of fi re, electric shock and personal injury, including the
following:
1. Important!
No hot particles nor ignition sources are allowed to
be sucked into the unit. Th e machine should not be
used for explosives, unstable or pyrophoric particles
or dust.
– WARNING Operators shall be adequately instruc-
ted on the use of these machines.
– WARNING Th is machine is for dry use only.
– CAUTION Th is machine is for indoor use only.
– CAUTION Th is machine shall be stored indoors
only.
2. Work area environment
Don´t expose the machine for rain. Don´t use it in damp
or wet locations or in presence of fl ammable liquids or
gases.
Overload
3.
Never let the machine operate fully throttled. Always
follow the regulations pertinent to the material you are
working with ie asbestos. Don´t use the machine for
purposes that it isn´t intended for.
4. Body injuries
Never let the suction come in contact with parts
of the body. Th e strong suction eff ect can hurt the
blood-vessels in the skin. Do not repair the electric
components yourself. Th e machine should be serviced
by qualifi ed personnel only. Faults may cause injury.
See also below under warnings.
5. Don´t abuse cord
Never pull the machine by thecord. Keep cord from
heat and sharp edges. Check the electric cable regularly
for damage.
6. Important measure
With cleaning and maintenance on the machine, the
power cable should be disconnected from the supply.
Maintain the machine with care
7.
Keep the machine clean and check that the hose
is undamaged and that all gaskets are tight. Follow
instructions. Keep handles dry and free from oil and
grease.
8. Checking for damage
Before futher use of the machine it should be carefully
checked that the machine is un damaged. If there are
any damaged parts these should be repaired by a Dust-
control authorized service center.
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualifi ed
persons in order to avoid a hazard.
9. Warning
Use only accessories and replacable parts which are
available in the Dustcontrol catalogue. When using
faulty parts or pirate parts (especially fi lter) the machine
could leak out unhealthy dust which can cause personal
injuries.
Th is appliance is not intended for use by persons (inclu-
ding children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concer-
ning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure
that they do not play with the appliance.
Th is machine is intended for commercial use only, for
example in hotels, schools, hospitals, factories,shops,
offi ces and rental businesses.
DC 4000 PCB - 9 Part No 94162-C