Makita DLS600 Manuel D'instruction page 15

To prevent the switch trigger from being accidentally pulled, a lock-
off button is provided. To start the tool, press in the lock-off button
and pull the switch trigger. Release the switch trigger to stop.
► 1. Lock-off button 2. Hole for padlock 3. Switch
trigger
Lighting up the lamp
CAUTION:
This is not a rainproof light. Do not
wash the light in water or use it in a rain or a wet area.
Such a conduct can cause an electric shock and fume.
CAUTION:
Do not touch the lens of the light, as
it is very hot while it is lighted or shortly after it is
turned off. This may cause a burn to a human body.
CAUTION:
Do not apply impact to the light,
which may cause damage or shorted service time to it.
CAUTION:
Do not keep casting the beam of the
light to your eyes. This can cause your eyes to be hurt.
CAUTION:
Do not cover the light with clothes,
carton, cardboard or similar objects while it is
lighted, which can cause a fire or an ignition.
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, press the upper position (I) of the switch.
To turn off the lamp, press the lower position (0) of the switch.
1
► 1. Lamp 2. Lamp switch
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: Be sure to turn off the switch as turning on the
switch consumes the battery power.
Laser beam action
1
Direct laser beam may injure your eyes.
2
To turn on the laser beam, press the upper position (I)
of the switch. To turn off the laser beam, press the lower
position (0) of the switch.
3
► 1. Laser switch
NOTE: Be sure to turn off the switch as turning on the
switch consumes the battery power.
Laser line can be shifted to either the left or right side of
the saw blade by turning the adjusting screw as follows.
► 1. Adjusting screw
1.
counterclockwise.
2.
adjusting screw to the right or left as far as it goes.
3.
where it stops sliding.
2
NOTE: Laser line is factory adjusted so that it is
positioned within 1 mm (0.04") from the side surface
of the blade (cutting position).
NOTE: When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to a
place where there is less direct sunlight.
15 ENGLISH
CAUTION:
Never look into the laser beam.
1
Loosen the adjusting screw by turning it
With the adjusting screw loosened, slide the
Tighten the adjusting screw firmly at the position
1