Makita DLS600 Manuel D'instruction page 23

Adjusting the laser line position
WARNING:
The battery cartridge must be
installed on the tool while adjusting the laser line.
Take extra care not to switch on the tool during
adjustment. Accidental start up of the tool may result
in serious personal injury.
CAUTION:
Never look directly into the laser
beam. Direct eye exposure to the beam could cause
serious damage to your eyes.
NOTICE:
Check the position of laser line regu-
larly for accuracy.
NOTICE:
Beware that impacts to the tool. It may
cause the laser line to be misaligned or may cause
damage to the laser, shortening its life.
NOTICE:
Have the tool repaired by a Makita autho-
rized service center for any failure on the laser unit.
The movable range of laser line is decided by the range
adjustment screws on both sides. Perform following
procedures to alter the laser line position.
1. Remove the battery cartridge.
2. Draw a cutting line on the workpiece and place it
on the turn base. At this time, do not secure the work-
piece with a vise or similar securing device.
3. Lower the handle and align the cutting line with the saw blade.
► 1. Cutting line
4. Return the handle to the original position and secure
the workpiece with the vertical vise so that the workpiece
does not move from the position you have determined.
1
► 1. Vise
5.
the laser switch.
6.
away from the blade, turn the range adjustment screws
counterclockwise. To move the laser line close to the
blade, turn the range adjustment screw clockwise.
Adjusting the laser line on the left side of the blade
► 1. Adjusting screw 2. Range adjustment screw
Adjusting the laser line on the right side of the blade
1
► 1. Range adjustment screw 2. Hex wrench 3. Laser
7.
laser line comes onto the cutting line and then tighten.
23 ENGLISH
Install the battery cartridge to the tool and turn on
Loosen the adjusting screw. To move the laser line
1
4
3. Hex wrench 4. Laser line 5. Saw blade
1
4
line 4. Saw blade
Slide the adjusting screw to the position that the
2
3
5
2
3