PREPARING & USING
THE NINJA HOT & COLD BREWED SYSTEM™
Fig. 17
SIGNATURE BREW
SPECIALTY BREW
NOTE: Specialty always yields 4 oz.
CP307 P4 BACKLIT UI LAYOUT
2017.12.21
of coffee and 6 oz. of tea (with the
exception of Green tea, which
yields 2 oz.).
1 After filling the water reservoir,
insert either the COFFEE or TEA
filter holder into the brew basket.
Add the ground coffee, loose leaf
tea, or tea bags to the filter.
2 Close the brew basket, ensuring
it is securely in place. The control
panel will display either COFFEE
(Fig. 14a) or TEA (Fig. 14b) settings
based on the filter holder that has
been inserted.
3 Place the empty vessel you would like
to brew into under the brew basket.
NOTE: If brewing an iced blended
drink, fill the desired vessel with the
amount of ice recommended in the
recipe before brewing.
4 Turn the START/SELECT dial to
choose SPECIALTY (Fig. 17). If
brewing tea, press the Tea button
to toggle to the tea menu, and
use the dial to choose your tea
type. To change your brew style
while in the tea menu, press the
Tea button
again.
16
1-877-646-5288
Fig. 18
5 Press the START/SELECT dial to
start the brew. A progress bar on the
control panel will show the status
of the brewing cycle. To cancel the
brew at any time, press the dial again
or press the Power button.
NOTE: The brewing cycle will begin,
then pause for a short period before
resuming. This process is used to evenly
saturate the coffee grounds or tea.
6 The unit will beep and the clock
will display End when the brew
is complete.
SETTING THE DELAY BREW
NOTE: The unit must remain on for the
Delay Brew function to work. DO NOT
power off after setting Delay Brew.
1 Turn the unit on by pressing the
Power button.
NOTE: The clock will remain on even if
the unit is turned off. Ensure the unit is
powered on to set Delay Brew.
PREPARING & USING
THE NINJA HOT & COLD BREWED SYSTEM™
Fig. 19
2 After filling the water reservoir and
adding ground coffee or tea to the
correct filter holder, be sure the
reservoir, brew basket, and filter
are securely in place. Place the
appropriate-size vessel under
brew basket.
NOTE: The brew basket must be
securely closed with either the COFFEE
or TEA filter inserted to set Delay Brew.
3 Press DELAY BREW. DELAY BREW
will illuminate and the clock will begin
to flash "12:00" or the last Delay Brew
time that was set (Fig. 18).
4 While the clock is flashing, press
the hour (H) or minute (M) button
to set the time that you would like
the Delay Brew to begin. The AM or
PM indicator will illuminate on the
left side of the display as you are
setting the desired time.
5 Once the proper time has been set,
select the size of the vessel that you
would like to brew into.
6 Turn the START/SELECT dial to
choose your brew style. If brewing
tea, press the Tea button
to
toggle to the tea menu, and use
the bottom dial to choose your tea
type. To change your brew style
while in the tea menu, press the
Tea button
again.
Fig. 20
Fig. 21
7 Once the time, brew size, brew
style, and tea type (if applicable)
have been set, allow DELAY BREW
to stop flashing, or press DELAY
BREW to activate. When activated,
the unit will beep and DELAY BREW
and your selected options will
remain illuminated. To cancel,
press DELAY BREW again.
NOTE: If you attempt to change your
selections while Delay Brew is set, the
unit will beep and DELAY BREW will
flash. To change your selections, cancel
the Delay Brew.
FROTHING MILK
1 Pour milk into cup, until it is about
/
full. (Use more or less milk
1
3
depending on your preference.)
Microwave for 45 to 60 seconds
for hot milk.
2 Move the frother into the ready
position by swinging the arm
toward the front.
3 Hold the cup under the frother and
submerge the whisk just below the
surface of the milk. This allows air
to fold into the milk for the frothiest
results (Fig. 19).
4 Press and hold the frothing button
for 30 to 45 seconds (Fig. 20).
5 You can easily remove the frother
whisk by twisting it clockwise. To
avoid spills, keep your cup below
the whisk and carry it to your sink
or dishwasher for cleaning (Fig. 21).
ninjakitchen.com
17