Setting The Clock & Program "Prog" Delay Brew - Ninja CF080C Manuel Du Propriétaire

Setting the Clock & Program "PROG" Delay Brew
AM
PM
Fig. 1
TO SET THE CLOCK
1 Plug the power cord into an electrical outlet. The clock
will flash on the control panel to indicate that the time
has not been set. (Fig. 1)
2
Press the H (hour) or M (minute) button until you reach
the current time. The AM or PM indicator will illuminate
on the left side of the display as you are setting the
time.
3
After 5 seconds the clock will stop flashing and the
clock will be set.
NOTE: If the clock stops flashing and does not display
the correct time of day, pressing the H (hour) or the M
(minute) button at any time will cause the clock to flash
again. You can now re-program the correct time of day
by following the steps above.
NOTE: If you unplug the brewer or in the event of an
extended power loss, you will need to reset the clock
the next time the brewer is plugged in.
TO PROGRAM THE DELAY BREW TIME
NOTE: The Ninja Coffee Bar
the delay brew function to work. Do not power off after
setting Delay Brew.
1
Press the PROG button. The PROG button will illuminate
and the clock will begin to flash "12:00" or the last
delay brew time that was set. (Fig. 2)
2 While the clock is flashing, press the H (hour) or M
(minute) button to set the time that you would like
the delay brew to begin. The AM or PM indicator will
illuminate on the left side of the display as you are
setting the desired time.
11
1-877-646-5288
H
M
Fig. 2
must remain on in order for
™
H
AM
PM
M
3
Once the proper time has been set, select the size of
the vessel that you would like to brew.
4
Select the Brew Type that you desire from the 4 flashing
buttons. The selected brew type will be lit. (Fig. 3)
5
Once the time, brew size, and brew type have been set, allow
the PROG button to flash and lock in or press the PROG
button to activate the Delay Brew time. When the Delay Brew
is activated, the light on the PROG button will illuminate and
an audible signal will play to verify the Delay Brew is set.
6
The Delay Brew time is now set and your Ninja Coffee Bar
will automatically brew at the time you programmed.
NOTE: To deactivate the Delay Brew cycle, press the PROG
button once more and the light on the PROG button will turn
off. Any change to the selected brew size or starting any other
brew will cancel the programmed Delay Brew time.
7
Place the appropriate-sized vessel
under brew basket for the selected
size.
IMPORTANT: Make sure the
Drip Stop is in the open position.
Go to ninjakitchen.com for more
information and how-to videos.
H
AM
PM
M
Fig. 3
™