Battery Insertion; Connections; Preliminary Settings - Compex Fit Mode D'emploi

Battery insertion

Open the cover of the battery compartment and insert the battery with the label
upwards so that the + and - poles of the battery are facing the contacts on the device.
Then replace the lid. If the device is not to be used for more than 3 months, ensure the
battery is fully charged. If the device is not to be used for more than 6 months, ensure
the battery is fully charged and remove it from the stimulator. Before removing the
battery, switch off the stimulator.

Connections

Connecting the charger
EN
The Compex has considerable operating autonomy, as it uses a battery. To recharge,
connect the charger supplied with your device to the base of the device, then plug
the charger into a socket. Remove any stimulation cables connected to the stimulator
before recharging it. We strongly recommend you to charge the battery fully before
using it for the first time as this will improve its performance and life span.
Connecting the cables
The stimulator cables plug into the 4 sockets on the front of the device. Cables can be
connected simultaneously to the four channels of the device. Both the sockets and
the cables are colour-coded to simplify use and facilitate identification of the different
channels:
blue = channel 1 green = channel 2 yellow = channel 3 red = channel 4

Preliminary settings

Before using the unit for the first time, you have the possibility to choose the working
language of the device and to specify a certain number of settings (display contrast
adjustment, backlight adjustment, and sound volume setting). This options screen can
subsequently be accessed by switching off the device and then pressing the On/Off for
more than 2 seconds.
153