Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
greater accumulation of dirt on the fixture's optics.
Clean with soft cloth using normal glass cleaning fluid.
Always dry the parts carefully.
Clean the external optics at least every 20 days.
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy
troubleshooting:
The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.
Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
fixture or the previous one.
o
Try to use another DMX controller.
o
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
Some fixtures don't respond to the easy controller
o
You may have a break in the DMX cabling.
o
Check the LED for the response of the master/ slave mode signal.
No response to the sound
o
Make sure the fixture does not receive DMX signal.
o
Check microphone to see if it is good by tapping the microphone.
Technical Specifications
Model
Voltage
Power consumption:
LED
Gross Weight
Package Dimensions
Diamond 19x15z Manual Ver. 1.00
Diamond 19x15 Z
110V- 250V / 50-60Hz
300W
19 pcs 15 Watts RGBW 4 in 1 OSRAM
15.55 kg
470(H) x 425(l) x 540 (L) mm
DMX
22
Page
Publicité
Table des Matières
