Sigma EF-610 DG Super Mode D'emploi page 25

Setting the Slave Flash unit(s) for firing
1. Attach the firing flash unit to the camera body.
2. Set the camera's exposure mode to S or M mode.
Then set the shutter speed to 1/30 or slower. The slave
◆
Controller will transmit the designated signal before the others
fire. Thus if you use a shutter speed faster than 1/30, the firing
flash units will not be synchronized.
3. Switch "ON" the flash unit, and press the camera's shutter button halfway.
Now, aperture value and film speed are automatically transmitted to the slave flash unit.
◆
4. Remove the slave flash unit from camera.
5. Press the MODE button and select the
6. Press the SEL button to make the channel display indicator blink.
7. Press the + button or – button to set the channel number. (C1 or C2)
8. Press the SEL button to make the output amount display indicator of flash blink.
9. Press the + button or – button to set the flash output amount.
Set the flash power by setting the distance indicator on the LCD panel to coincide as closely as
◆
possible with the actual distance from the slave flash to the subject. If the actual distance is out of
range, you need to change the aperture value.
10. Press the SEL button several times to make the display stop blinking.
11. Place the slave unit in the desired location. Do not place the slave unit within the picture area.
Setting for Slave Controller unit
12. Press the MODE button and select the
13. Press the SEL button to make the channel display indicator blink.
14. Press the + button or – button to set the same channel number
as that set on the firing flash unit.
15. Press the SEL button to make the flash output amount display
indicator blink.
16. Press the + button
17. Press the SEL button to make the display stop blinking.
18. Attach the Slave Controller flash unit to the camera body.
19. After you confirm that all flash units are fully charged, press the shutter button to take the picture.
When the firing flash unit of EF-610 DG SUPER SO-ADI is fully charged, the AF Auxiliary Light will blink.
◆
You cannot set the aperture value by SEL button, if you select the
◆
output amount. The flash unit will be set to the Slave Controller mode.
The Slave Controller unit functions only to control the slave unit.
◆
SPECIFICATIONS
TYPE : Clip-on type serial-controlled TTL auto zoom electric flash
GUIDE NUMBER : 61 (ISO 100/m, 105mm head position)
POWER SOURCE : Four AA type alkaline batteries or Four AA type Ni-Cd batteries or,
RECYCLING TIME : about 7.0 sec. (Alkaline batteries)
NUMBER OF FLASHES : about 120 flashes (Alkaline batteries)
FLASH DURATION : about 1 / 700 sec. (full power firing)
FLASH ILLUMINATE ANGLE : 24～105mm motor powered control (17mm with Built-in Wide Panel)
AUTO POWER OFF : Available
DIMENSIONS : 77mm (W) / 3.0in. x 139mm (H) / 5.5in. x 117mm (L) / 4.6in.
mark displayed.
: Four AA type Ni-MH Nickel-Metal Hydride batteries
: about 5.0 sec. (Ni-Cd, Ni-MH Nickel-Metal Hydride)
: about 160 flashes (Ni-Cd, Ni-MH Nickel-Metal Hydride)
WEIGHT : 330g / 11.6oz.
/ . (Slave Mode)
/ (Slave Mode).
mark at the setting of flash
24