Sigma EF-610 DG Super Mode D'emploi page 22

B. USING THE SIGNAL OF THE FLASH THAT IS ATTACHED TO THE
CAMERA AS THE TRIGGER
For Wireless Flash, two or more EF-610 DG SUPER SO-ADI flash units are necessary. EF-530 DG
SUPER SO-ADI can be used only with off-camera mode. Depending on the flash unit model of
off-camera flash, it is necessary to change the control mode of the controller. Please see the below
chart. (EF-610 DG SUPER SO-ADI can be used for the controller).
Flashgun model can be
used for off-camera flash
Control Mode
Camera model can be
used with off-camera flash
Ratio-Flash Control setting
Flash Mode
B-1.In the case of using only off-camera flash
Camera and Controller Setting
1. Set the camera to the wireless flash mode.
Since the settings vary depending on the camera model, please refer to the instruction manual for
◆
your camera.
2. Set the camera's exposure mode to P,A,S or M.
3. Attach the flashgun to the camera body.
4. The flashgun's LCD panel will be switched to the controller
setting display automatically.
switched automatically, press the
controller setting display appears.)
5. The control mode display will blink when the
pressed.
6. Set the control mode to
7. Channel information will blink when the
8. Set the channel number (C1 - C4) by pressing the
9. The ratio-flash control display will blink when the
10. Set the ratio-flash control mode to [
11. Press the
Off-Camera Flash Setting
12. Press the
13. Set the off-camera flash number to 1 by pressing the
14. Press the button to set the flash mode to TTL.
15. Channel information will blink when the
16. Press or
set on the controller.
17. Press the
18. Place the off-camera flash at the desired position.
19. Check that both flashes are fully charged.
21
EF-610 DG SUPER SO-ADI
+
α700, α900
It is possible to control up to 3
groups;Controller, Off-Camera
Flash 1 and Off-Camera Flash 2.
It is possible to set flash-ratio of
each group from 5 levels or
without falsh.
TTL Auto flash, High Speed Sync
Flash (TTL, M), Manual flash
(If the LCD panel will not be
by pressing the
button again, the display will stop blinking.
button until the off-camera flash display appears.
button to choose the same channel number as
button, the indicator stops blinking.
button until the
button is
or button.
button is pressed.
or button.
button is pressed.
] by pressing the
button.
button is pressed.
EF-530 DG SUPER SO-ADI
EF-610 DG SUPER SO-ADI
-
α900
It is possible to control 2
groups;Controller and Off-Camera
Flash.
Controller : It is possible to set the
ratio of off-camera flash to 1:2 or
2:1.
TTL Auto flash, High Speed Sync
Flash (TTL)
or button.