Cleaning And Maintenance; Before Calling For Service - Signature SCT1003A+X Instructions D'utilisation

Defrosting
Remove the mains plug from the wall socket, open the door and remove
all the food to a cool place. Defrost using a plastic scraper, or let the
temperature rise naturally until the frost melts. Then wipe away the
remaining ice and water, after this plug the freezer back into the mains
supply.

CLEANING AND MAINTENANCE

Cleaning your freezer
• Before you start to clean your freezer remove the mains plug from the
power supply.
• Use lukewarm water and bicarbonate of soda.
• Clean with a cloth soaked in this solution and then dry with a soft cloth.
PROLONGED OFF PERIODS
• If the freezer is not in use for a long period of time, proceed as follows:
• Disconnect the freezer from the main supply by removing the plug
from the wall socket.
• Clean and dry the inside as instructed under the heading of cleaning
the freezer.
• Leave the door open to prevent any unpleasant smells from building
up while the freezer is not in use.

BEFORE CALLING FOR SERVICE

Please check the following points:
• The freezer is not working
- Check the plug is inserted correctly into the wall socket
- Check there is power to the wall socket by plugging in another
appliance.
- Check the fuse in freezer plug.
• The freezer is noisy when running
- Check the freezer is level and it is not in contact with another
appliance or kitchen furniture.
• The freezer does not cool sufficiently
- If the door has been opened too often, or it has been left open for a
while it will take time for the freezer to reach its set temperature.
- Check the airflow the rear of the freezer has not been reduced due to
insufficient clearance.
-28-