Signature SCT1003A+X Instructions D'utilisation page 27

Reversing the door
This freezer has been built with the door hinges on the right. If you want
to change the opening direction, please follow the instruction below:
1. Take off the cover(1). Remove the four screws(2)(3) and take away
the top.
2. Remove the two screws(4) that hold the upper hinge(5) and take
away the upper hinge(5).
3. Unscrew the nut(7) and take off the bolt-pin(6). Reverse the up
hinge(5) and install the bolt-pin(6) and nut(7).
4. Lift the door and place it on a padded surface to prevent scratching
it.
5. Take off the leg(8). Remove the three screws(9) that hold the lower
hinge(10) and take away the lower hinge(10).
6. Unscrew the screw(12) and remove the leg(13). Then transfer it to right
side.
7. Remove the bolt-pin(11) and reverse the direction of lower hinge(10).
Install the lower hinge (10) into left side with three screws (9).
8. Insert the bolt-pin(11) to the lower hinge(10).
9. Remove the hinge pin (14)(15)(16) that is in the bottom of door. At the
other side of door, insert the replacement hinge pin that is supplied
with the appliance.
10. Set the door to its place and make sure the door seat at the lower
hinge (10).
11. Fix the upper hinge (5) with the two screws (4).
12. Install the top with four screws(2)(3) and cover screw (2) with cover
(1).
-25-