Environmental Protection; Blade Maintenance - F.F. Group ELM 32/1000 EASY Notice Originale

Masquer les pouces

Table Des Matières

Table des Matières

ELM 32/1000 EASY

assembly with both hands and tilt the handle

downward to slightly raise the front of the lawn

mower (Q). This will reduce the risk of lawn dam-

age during start-up.

3. Press and hold the safety button (m1) of the

switch assembly while pulling the on/off switch

lever (2) towards you. Once the machine powers

on, release the safety lock button (m1) (M).

4. Let the motor get up to speed, gently lowering

the lawn mower down into the cutting position

and start mowing (R).

STOPPING THE MOTOR

To stop the mower, release the ON/OFF switch le-

ver and it automatically returns to its OFF position.

GRASS COLLECTION BAG VOLUME INDICATOR (O)

1. If the grass collection bag is empty or is not com-

pletely full with grass, the grass indicator flap

will remain open (o1) (due to the flow of air) or

will flutter open and close as the grass accumu-

lates in the bag.

2. When the grass bag reaches its maximum capac-

ity, the grass indicator flap will remain closed

(o2) (due to the restricted air flow). This signals

that it is time to empty the bag.

MOWING TIPS (P)

For best results cut your lawn in alternative direc-

tions switching direction each time you cut. Cut

your lawn at an equal and same height. Slightly

overlap your cutting lines.

MAINTENANCE

WARNING! Before cleaning, repairing, or in-

specting the lawn mower, disconnect the

power supply to the unit and verify that all

moving parts have come to a complete stop.

GENERAL

Always keep the lawn mower clean and free of grass,

dirt, or other debris.

Keep the handles dry, clean, and free of oil and

grease.

After each cutting session, remove accumulated

grass clippings and debris using either a dry cloth

or hand brush. You may also clean the equipment

with a damp cloth. Do not use cleaning agents or

harsh solvents as they may damage the equipment's

plastic components. Make sure that no water pen-

etrates the equipment's interior as intake of water

can destroy the switch/plug mechanism and the

electric motor.

Do not clean the lawn mower with running water,

particularly with high-pressure water.

Check all nuts, bolts, and screws for proper tightness

before each use.

Frequently inspect the grass collection bag for signs

of wear and replace immediately with a genuine part

if damage is found.

Replace excessively worn or damaged parts imme-

diately.

BLADE MAINTENANCE

IMPORTANT! The mower blade is sharp and

can cause severe personal injury if handled in-

correctly. Wrap the blade or wear protective

gloves, and use extra caution when handling.

The steel blade is designed to provide a fine cut in

long or tough grass. Deterioration in the quality

of cut indicates blade wear or damage.

WARNING! An excessively vibrating lawn

mower indicates that the blade is not prop-

erly balanced or has become deformed from

striking an object. In this case, the blade

must be repaired or replaced. Please follow

the proper maintenance procedures for

blade care or call the service center.

BLADE REPLACEMENT (N)

WARNING! Wear heavy duty gloves when

handling the blade.

IMPORTANT! Only use original replacement

parts specified for this lawn mower.

1. Disconnect the electrical supply to the lawn

mower.

2. Turn the lawn mower on its side to expose the

underside of the blade housing.

3. Wear heavy-duty gloves, or use a cloth to grip

the blade.

4. To remove the blade bolt (n1), hold the blade

firmly by one hand, and use a spanner wrench

(n2) to loosen the blade bolt by turning it coun-

terclockwise.

5. Fit the new blade, the washer and the bolt back

on following the same steps in reverse order.