Installation - Elkron HP305 Manuel D'installation

INSTALLATION

1) Open the siren by release the screws.
2) Slide the cover on one side as shown on
figure 1.
The siren comes from the factory equipped with
anti-opening protection.
Anti-removal micro-switch set-up: remove the U
protection metallic cover (fig. 2) by unscrewing the
nut; remove the tingle which the micro-switch leans
on (figure 3) and fit a rawplug on the wall, close to
the siren, near the hole under the micro-switch
(figure 4).
Adjust therefore the rawplug screw (to protrude
from the wall of about 23 mm) until the micro-
switch goes off, when the cover is in place.
Finally re-apply the U protection metallic cover and
close the nut again.
A
A
JP1 JP1 JP2 JP2 JP3 JP3 JP4 JP4
JP5 JP5
JP6 JP6
+
_
_
TAMPER TC1 TAMPER BL1 BL1
TC1 + BL2 BL2
B
A
C
13/16
Fig. 3
3
2
1 3) Fix the siren to the wall using the
rawplugs in the kit, utilising the holes
provided.
A = Wall fixing holes
B = Cable entry hole
C = Lodging for eventual battery
(not supplied)
Running of connecting cable is facilitated
by the fixing holes embossing.
Fig. 1
Fig. 2
Fig. 4
HP305 / HP305P