How to change the battery in the
radio-operated handle (dia. 42)
^ Open the cover to the battery
compartment using a screwdriver.
^ Replace with a new battery, making
sure the polarity is correct.
^ Replace the cover.
^ Dispose of the old battery
responsibly.
When to change the thread lifters
The thread lifters on the suction inlet of
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.
How to replace the thread lifters (dia.
43 + 44)
^ Use a suitable screwdriver to remove
the thread lifters from the slots.
^ Fit new thread lifters.
Upholstery nozzle SPD 10 (dia. 45)
^ Disengage the thread lifter unit at
each side of the upholstery nozzle
using a coin.
^ Fit a new thread lifter unit and lock
into position.
Cleaning the roller on the floorhead
(dia. 46)
(Not necessary for the AirTeQ floorhead)
a Release the bearing (with bayonet
fitting) using a coin.
b Press the bearing out, and remove it.
c Take out the roller.
^ Remove any threads and hair,
replace the roller and refit the
bearing.
Replacement parts are available from
your Miele retailer or from Miele (see
back cover for contact details).
Cleaning and care
,
Always disconnect the vacuum
cleaner from the electrical supply
before cleaning it. Switch off at the
wall socket and unplug it.
Vacuum cleaner and accessories
External surfaces of the vacuum
cleaner and of the accessories can be
cleaned with a proprietary cleaner
suitable for plastic.
,
Do not use abrasive cleaning
agents, glass cleaning agents,
all-purpose cleaners or oil-based
conditioning agents.
Dust compartment
The dust compartment can, if necessary,
be cleaned using a dry duster, brush
or, if available, a second vacuum
cleaner to vacuum the dust out.
,
Do not let the vacuum cleaner
get wet. If moisture gets into the
appliance, there is a risk of electric
shock.
en
47