Miele S 8310 Mode D'emploi page 40

en
Some models also have symbols on the
controls. The symbols indicate the type
of use the settings are suitable for.
The setting selected will light up yellow.
# - curtains, lightweight fabrics
$ - upholstery, cushions
% - thick pile carpets, rugs and
runners
* - for energy-saving vacuuming
(this setting is also very quiet)
( - loop-pile carpets
) - heavily soiled hard flooring and
for intensive cleaning of carpets
,
When using the AirTeQ
floorhead, if the suction seems too
high, reduce the suction until the
floorhead is easier to manouevre.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power
selectors:
+ /- foot controls (dia. 21)
The first time the vacuum cleaner is
switched on, the highest power setting
will be selected automatically.
After that, the vacuum cleaner will
switch on at the setting which was used
previously.
^ Press the + foot control to select a
higher setting.
^ Press the - foot control to select a
lower setting.
40
Foot controls with Automatic (dia. 22
+ 23)
The first time the vacuum cleaner is
switched on, the "Auto" power setting
will be selected automatically.
Auto = suction power is automatically
adjusted for the type of floor
being vacuumed
,
Do not use the "Auto" setting to
vacuum lightweight materials or
curtains. These could be sucked in
and possibly damaged.
^ Press the + control to change to
"Turbo", the highest power setting.
^ Press the - foot control to change to
"Min.", the lowest power setting.
After that, the vacuum cleaner will
switch on at the setting which was used
previously.
Radio-control handle with Automatic
(dia. 24)
When the vacuum cleaner is switched
on with the On/Off foot control s, the
Stand-by - indicator on the vacuum
cleaner will light up yellow.
^ Press the Stand-by button - on the
handle.
The Stand-by indicator - on the
vacuum cleaner will go out.
The first time the vacuum cleaner is
switched on, the highest power setting
will be selected automatically.
After that, the vacuum cleaner will
switch on at the setting which was used
previously.