Operating - Medisana HU 650 Mode D'emploi

GB

3 Operating

3.1
Use
3.2
Operation
12
With the MEDISANA HU 650 / HU 655 heated underblankets you can gently
warm and relax your whole body. Using the blanket stimulates the circulation
in areas of tense muscle and promotes a sense of well being after a strenuous
day. The heated underblanket is warmer around the feet and provides a
pleasant temperature in bed, allowing you to relax and get to sleep quickly.
Spread the blanket out flat on top of the mattress. Pull the edges like a fitted
sheet over the mattress or other suitable undersurface.Make sure that the
electric underblanket is firmly strapped to the mattress in both directions and that it
will not crease while it is being used. Spread a bedsheet on top of it. This allows the
underblanket to release its heat in the best way possible. Check it is in the correct
position before going to bed!
The blanket may only be used when it is spread out flat. The heated
underblanket features an electric temperature control that regulates the
temperature according to the chosen setting.
We recommend switching on the heated underblanket 30 minutes before
going to bed.
Plug the blanket into the mains outlet and move the selector switch from
position 0 to position 1. The geen power LED will light up. You will feel the
blanket gradually warming up. This will be even more noticeable if it is covered
with a quilt. If you require a higher temperature setting, move the switch to
one of the higher settings, position 2, 3 or up to the maximum heat setting,
position 4. Should the blanket get too warm for you, slide the switch back to
a lower setting.
To switch off the blanket, return the switch to position 0. The green power LED
will go out, indicating that the unit is switched off.
The heated underblanket is designed in such a way that settings 1 and 2 are
suitable for continuous use while you sleep. Settings 3 and 4 are best suited to
pre-warming the bed.
The blanket will switch off automatically after approx. 3 hours of continuous
use. To switch it back on, first move the switch back to position 0, then back
to the desired heat setting.
The unit is fitted with an overheat cut-off, which also switches the unit off
automatically if there is any risk of it overheating. Always allow the unit to cool
down fully before you use it again.
Unplug the blanket from the mains outlet when it is no longer in use.