Operating - Medisana HDF Mode D'emploi

GB

2 Operating

2.2
Operation
12
Always make sure that the foot warmer is not creased or folded while it is in
use. You must always use the foot warmer with both covers.
Switch the appliance on with the sliding switch on the control unit. Never use
a clock timer!
Switch level 0 = Appliance switched off
Switch level 1 = Heat low
Switch level 2 = Heat medium
Switch level 3 = Heat high
While the foot warmer is heating up, the indicator light is lit. As soon as the
indicator light goes out, this means that the heat level set has been reached
and will be maintained.
You can now enjoy the pleasant warmth at your feet. After approx. 120 min-
utes the foot warmer automatically switches off. To switch the foot warmer on
again, you must first move the sliding switch to position 0. After approx. 5 sec-
onds you can switch the foot warmer back on by sliding the switch to level 1,
2 or 3. You can stop using the appliance at any time by moving the sliding
switch to position 0. Disconnect the plug from the mains socket when you are
not using the foot warmer.
WARNING
When the foot warmer is in operation, the control unit may warm
up slightly. For this reason, the control unit must not be covered
or placed on the foot warmer while the appliance is switched on.
Do not rely on your hands to test the heat of the foot warmer.
Hands are considerably less sensitive towards heat than the rest
of the body's surface. A temperature which is judged by the hand
to be slightly warm can be felt by the feet to be unpleasantly hot.
The indicator light also goes out if the safety system switches off
the foot warmer due to a fault, even if the foot warmer is still
switched on. The foot warmer must no longer be used after a
fault has occurred. This is because safe operation of the appliance
can no longer be guaranteed.