Copy System - Velux KLF 100 Notice D'utilisation

System settings

Copy system

H
If the products have been registered directly in the
interface/repeater unit as shown on page 24, they can
be copied to other interfaces/repeater units or remote
controls.
the copying takes place in two steps.
Step 2 must be completed within two minutes after
implementing step 1, so please read steps 1-2 before
proceeding.
The example shows how to copy the registered products
from the interface/repeater unit to a VELUX remote
control not yet in operation.
Step 1: Interface/Repeater unit A
1
Menu item H is highlighted.
Press to highlight "Copy system".
Press "Enter" to confirm your choice.
30 VELUX
A
A B C D E F G
SySTEM SETTINGS
Select products
Security key
Copy system
Enter
ENGLISH
Step 2: Remote control B
2
Insert the three batteries supplied (type AA, 1.5 V)
into the remote control as shown.
3
Choose language:
Press to highlight your language.
B
Press "Enter" to confirm your choice.
4
Press "Register" to start registration.
H
Back
5
Registration is running. This might take up to several
minutes.
6
The display shows "Completed" when all products have
been registered.
Note: For other types of activation controls, please refer
to the instructions provided with the product in question
to execute step 2.
LANGuAGE
Dansk
English
Français
Deutsch
Enter
P1
AuTO SET-uP
Prepare products
for registration and
press Register
within 10 minutes
Register
P1
AuTO SET-uP
P1
AuTO SET-uP
Completed
P1
ENGLISH
B
P2
Back
P2
P2
P2
VELUX 31