Installation; Pre-Installation Review; Unpacking - Kinetico Water Systems TX Série Guide Du Propriétaire

I
NSTALLATION
The following procedures have been developed to assist you during the installation of your TX 1440 Whole
House RO.
The installation of this RO should be performed by a
qualified service person with an understanding of local and
regional codes that may affect the installation requirements.

Pre-installation Review

Before beginning the installation of the RO system, confirm system configuration to be installed, and
components that have been ordered. Please review RO system specification sheet that includes required
components.
Review of the customer's facility is also recommended, especially critical operating data that could affect the
operation of the system:
Water Pressure
Water pressure to the RO system will affect the maximum
flow permitted by the system. The RO system will not
operate if the inlet pressure fluctuates below a dynamic
pressure of 15 psi (1.0 bar). This minimum pressure must
be maintained to the system at all times. Should the
pressure fluctuate below this level, a booster pump may be
required. Maximum feed water pressure to system is 70 psi.
Temperature
Ambient temperature must be maintained above 32°F (0°C).
Freezing temperatures will cause breakage of equipment
and void all warranties.
Water Temperature
Inlet water temperature must be maintained between 35°F
and 90°F to prevent damage to the system's membranes.
System Location
The unit is designed for indoor or outdoor installation. All
electrical components are water-tight rated, and all exposed
construction materials are UV resistant.
RO Installation
Tools and Installation Materials
Since the RO processes high quality water and plumbing
runs on the process, purge and drain outlets should all be
completed with PVC piping or polyethylene tubing. Copper
and galvanized pipe may demonstrate corrosion
characteristics when subjected to permeate quality water.

Unpacking

1) Remove the RO from its packaging.
2) Inspect unit for possible shipping damage:
-broken fittings
-dents or scratches
3) Check all connections and mounting bolts. Tighten as necessary as they may have loosened during
shipment.
Kinetico Incorporated  Corporate Headquarters  Newbury, Ohio 44065  440-564-9111
Rev. 11/2016
12
TX Series Owners Manual
Product No. 13591E