Function Instruction - Danby DWC040D2BSSDB Guide D'utilisation Et Soins De Propriètaire

Operating Instructions
CONTROL PANEL
1. Power Button: Press once to turn the unit on. Press and hold for 3 seconds to turn the unit off.
2. Light Button: To control the inner light turn ON/OFF. Press this button to have the light continu-
ously illuminated; lighting will not be controlled by opening or closing the door.
3. Indicator Light: illuminates to signify the cooling mode is currently in operation.
4. °C / °F: Adjacent indicator light denotes which scale of temperature is being displayed.
5. Upper Display: For viewing the temperature of the upper zone.
6. Lower Display: For viewing the temperature of the lower zone.
7. Upper Button: Used to set the temperature in the upper zone.
8. Lower Button: Used to set the temperature in the lower zone.
Setting the Temperature Controls
When you plug in your wine cooler for the fi rst time the temperature will automatically be set to 6°C
(43°F) in the upper zone and to 12°C (54°F) in the lower zone. The default setting is °F.
• The temperature can be set as low as 5°C (41°F) or as high as 18°C (64°F) to suit your specifi c
storage requirements. Each depression of the
perature in 1° increments within the aforementioned range.
• To switch the display between °F and °C, depress the
3-5 seconds.

FUNCTION INSTRUCTION

Door Ajar Alarm Function
• The door ajar alarm will sound if the door is left open for more than 5 minutes. Ensure that the
door is completely closed to avoid the loss of cold energy.
• If the door ajar alarm sounds and the door is completely closed, ensure that the rubber gasket on
the inside of the door is making a solid seal with the cabinet all the way around and the extrusion
board for the lamp switch is making solid contact with the switch.
Temperature Memory Function
• If power is lost, the set temperature will be saved by the unit. Once the power is back on the unit
will return to the same set temperature.
Temperature Alarm Function
• If the inner temperature is higher than 23°C (73°F), "HI" is shown on the display panel and the
alarm will sound after one hour to alert you that the inner temperature is too high.
• If the inner temperature is lower than 0°C (32°F), "LO" is shown on the display panel and the
alarm will sound.
If too many bottles are put in at once or if the door has not been closed tightly, the unit will
display the "HI" signal in the display panel. This is normal, please wait 5 minutes after you
close the door and "HI" will disappear.
It is normal that the cabinet shows "HI" or "LO" from time to time. If it occurs frequently or
lasts for a long time, you can restart the unit by unplugging it. If the problem occurs once
again after restart, please contact customer service.
3
1
2
or
6
4
7
° °
°
°
6
5
button will allow you to adjust the tem-
and simultaneously for approximately
8