Leveling Instructions; Wine Storage - Danby DWC040D2BSSDB Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

LEVELING INSTRUCTIONS

Beneath the wine cooler there are two leveling legs that are
located on either side of the vent. It is important that your wine
cooler is level. To level the unit:
1. Move the wine cooler to its fi nal location.
2. Have someone gently lean against the front of the wine cooler
to take some weight off the leveling legs.
3. Turn the leveling legs clockwise to raise the wine cooler or
counter-clockwise to lower it. Continue in this manner until the
wine cooler is level.

WINE STORAGE

The maximum storage capacity of your wine cooler is 38, 750 ml bottles. Ensure that wine is stored
in sealed bottles only. Do not cover shelves with aluminum foil or any other material that will prevent
adequate air circulation within the cabinet.
To achieve the maximum capacity of thirty-eight
bottles, position a total of seven bottles alternately
(head-to-tail) on the upper four full shelves, as
shown in Fig. A.
Fig. A
SHELVES
Make sure the shelf is aligned with the lock block when taking the shelf
out or putting it back into the unit.
To remove a rack from its locked position, tilt the rack as shown in Fig. C
and pull outward.
To re-install, ensure the rack is resting securely on the support brackets
and push the rack inward until it locks into place.
Raises
the Leg
(lowers
the unit)
Place fi ve bottles on the bottom two half
shelves, as shown in Fig. B.
Fig. B
7
Fig A
Lowers
the Leg
Fig. C
(raises
the unit)