ENG
Yarn Embellishment Foot Set
With the HUSQVARNA VIKING
you can easily create decorative yarn embellishment when sewing. The
embellishment is created when sewing using the specially designed stitches
for this foot together with yarn. The effect of the embellishment can be
changed dramatically by using different types of yarn.
This presser foot is designed to be used with specially designed stitches.
These stitches can be downloaded at www.husqvarnaviking.com.
Note: No stitches except for the specially designed stitches can be used.
The yarn foot is equipped with an adjustment wheel. The wheel is used
to fine tune the red line so that it matches the center needle position on
the foot.
When the needle is centered at the redline, it is more
likely that the yarn foot will pick up a wider range of yarn.
1
2
3
For more
information go
to the online
Accessory
User's Guide!
© 2014 KSIN Luxembourg II, S.ar.l. All rights reserved. VIKING, DESIGNER DIAMOND, DESIGNER RUBY, SAPPHIRE and DESIGNER are trademarks of KSIN Luxembourg II, S.ar.l. HUSQVARNA and the "crowned H-mark" are trademarks of Husqvarna AB.
All trademarks are used under license by VSM Group AB.
Yarn Embellishment Foot Set,
®
4
5
Contents
A. Yarn guides (for DESIGNER DIAMOND™ series, DESIGNER
RUBY™ series, SAPPHIRE™ 960Q, except for DESIGNER™ SE)
B. Yarn guides (for DESIGNER™ SE and DESIGNER™ SE
Limited Edition).
C. Yarn Foot
D. Yarn threader
– Stitches to download
A
C
Preparing the machine for couching
1. Thread the machine with a thread that matches the decorative yarn or
use transparent thread.
2. Attach the yarn guides to your machine in the notches under the handle at
the rear side of the machine (See ill. 2).
3. Pull out as much yarn as you need from the ball of yarn and place it as
shown in ill. 3. Make sure to pull out the yarn continuously to avoid too
much strain on the yarn.
4. Place the yarn in the yarn guides (See ill. 3). It is very important that
the yarn runs smoothly while you are sewing.
5. Thread the yarn from above through the hole in the Yarn foot using the
yarn threader (see ill. 4). We recommend using yarn with even thickness.
For best result the yarn should fill the hole in the foot but still run easily
through it.
6. Snap the foot onto the machine. (See ill. 5).
7. Select the stitch you want to sew. Before starting to sew, use the
adjustment wheel to make sure the redline on the foot is matching the
needle. (See ill. 1).
Tips: Draw a line on the fabric with a fabric marker, for easier guidance.
Note: Some yarn work better than other. Yarn with a looser structure will often give a
better result.
Where to find the
stitches for download
To download the stitches, go to
www.husqvarnaviking.com.
Find the Yarn Embellishment
Foot Set.
Click on the link to download
the stitches.
413 14 20
413 14 21
413 14 20
413 14 21
B
D
3