Select The Temperature Adjustment; Calibrating The Thermal Probe - Bticino HC4451 Manuel D'utilisation

 Select the Temperature adjustment

This setting lets you choose the type of temperature adjustment
according to the type of system.
1: Standard default (recommended)
2: Proport. 5min low-inertia systems (fan-coil)
3: Proport. 10min medium-inertia systems (aluminium radiators)
4: Proport. 20min high-inertia systems (cast iron radiators)
• Use the ÅÇ keys to select the option "Adjustment"
• Press OK to confirm
The display shows the currently set selection.
• Use the ÅÇ keys to select the required adjustment
• Press OK to confirm and to go back to the previous page or press
C to exit the menu and to return to the previous page, hence
cancelling the change.

 Calibrating the thermal probe

This setting lets you calibrate the measurement of the internal and
external probe.
• Use the ÅÇ keys to select the option "Calibration"
• Press OK to confirm
If the external probe is set as a floor probe or used for the outside
temperature, the selection of the probe will be given.
• Use the ÅÇ keys to select the probe
• Press OK to confirm
If the external probe is not operative, the calibration menu of the
internal probe will be displayed directly.
If the external probe is set for measuring the ambient temperature,
the calibration menu of the external probe (internal probe inoperative)
will be displayed directly.
• Use the ÅÇ keys to change the temperature
• Press OK to confirm and to go back to the previous page or press
C to exit the menu and to return to the previous page, hence
cancelling the change.
If you RESET the Chronothermostat, the temperature offset
determined during the Calibration will be removed.
59
Customizations
2