Set The Measurement Unit Of The Temperature; Enable/Disable The Remote Control; Adjust The Display Contrast; Select The Screen Saver - Bticino HC4451 Manuel D'utilisation

2
Customizations

 Set the measurement unit of the temperature

Sets the measurement unit of the temperature: Celsius or Fahrenheit
(default is Celsius).
• Use the ÅÇ keys to select the option "Degrees"
• Press OK to confirm
A screen will be displayed showing the indication of the preset
measurement unit.
• Press OK to change the measurement unit
• Press C to exit the menu and to return to the previous page.

 Enable/Disable the Remote control

Enables/Disables the remote control using a telephone actuator of
the Chronothermostat (default is Enabled).
The remote contact is managed as follows:
Closed= antifreeze mode activation
Open= last set weekly programme
• Use the ÅÇ keys to select the option "Remote control"
• Press OK to confirm
The display shows the preset status.
• Press OK to change the status
• Press C to exit the menu and to return to the previous page.

 Adjust the Display contrast

Adjusts the contrast of the graphic display.
• Use the ÅÇ keys to select the option "Contrast"
• Press OK to confirm
• Press OK to confirm and to go back to the previous page or press
C to exit the menu and to return to the previous page, hence
cancelling the change.

 Select the Screen Saver

Selects what you want to show on the Chronothermostat display
when in idle condition (default is Temp/date/time).
You can select the following:
1: Only Temp. - temperature measured
2: Temp./date/time - temperature measured and date/time
3: Main - complete main screen
4: Off - display completely off
• Use the ÅÇ keys to select the option "Screen Saver"
• Press OK to confirm
The display shows the currently set selection.
• Use the ÅÇ keys to select the "Screen Saver"
• Press OK to confirm and to go back to the previous page or press
C to exit the menu and to return to the previous page, hence
cancelling the change.
Please note:
maximum battery duration is guaranteed when the display is OFF.

 Select the Language

Selects the language for the menu (default is Italian).
• Use the ÅÇ keys to select the option "Language"
• Press OK to confirm
The display shows the currently set selection.
• Press OK to confirm and to go back to the previous page or press
C to exit the menu and to return to the previous page, hence
cancelling the change.
58