Temperature Display Detected By The Separate Probe; Statistics - Bticino Polyx Clima Manuel D'utilisation

3
Advanced operation
Resetting the preset parameters
To reset the temperature profiles as well as the preset temperature
values (T1-T2-T3 - Temperature used in manual mode, Tempe-
rature used in Jolly mode, antifreeze Temperature - Off function)
press and hold down the
p q
in temperature profile programming mode.
Temperature display detected by the

separate probe
In order to display the temperature detected by the separate
probe (only if configured as an outside probe or floor probe), the
chronothermostat must be configured, see <<Chronothermostat
configuration>>, and the probe must be connected.
To display the temperature value read by the separate probe, press
the operation mode key currently being used (the temperature
flashes). To display once again the temperature detected by the
chronothermostat, press the operation mode key currently being
used again (the temperature will no longer flash).
keys simultaneously when you are

Statistics


The chronothermostat provides statistical data on how the system
functions.
To access the data, do the following:
1 - Go to the main page of the programming menu. The opera-
tion mode being used will be temporarily stopped. Select the
statistics function.
2 - Page 1: system ON hours the day before. Use the
continue to the next page.
3 - Page 2: total ON hours since it was first turned on. Use the
key to continue to the next page.Press the
taneously to reset the total ON hours.
4 - Page 3:minimum temperature reached on the current day and
time of when it was reached. Use the
next page.
5 - Page 4: maximum temperature reached on the current day
and time of when it was reached.
6 - Press ENTER twice to return to the previously used operation
mode.
40
key to
u
u
keys simul-
p q
key to continue to the
u